Appliance RepairWasher RepairTampa Bay, FL

Washer repair in Tampa Bay starts with a specific symptom: won't spin, won't drain, won't start, making noise, or leaking. Each points to a different set of components. We diagnose first, then quote.

Won't drain: drain pump failure or a clogged drain hose. On front-loaders, check the coin trap filter first — a blocked filter causes the drain pump to fail prematurely, and the filter is a two-minute DIY fix once you know it's there. Won't spin: drive belt failure on belt-drive models, motor coupling on direct-drive top-loaders, lid switch failure (top-loaders), door latch failure (front-loaders). Won't start: lid switch, door latch, or control board.

Front-load washers in Tampa Bay fail most often on the bearing or suspension rods. Bearing failure is a loud, progressive grinding roar during the spin cycle — it gets worse over months. Suspension rod failure causes the drum to bang against the cabinet during spin.

For Samsung suspension rods: the OEM set runs $420 for four. We use an aftermarket set at $45 that's physically heavier built — thicker shaft, thicker spring, rubber sleeve on the spring. A customer had already installed the OEM set. Same banging came back. The aftermarket set went in. No callback since.

We work on all major brands: Samsung, LG, Whirlpool, GE, Maytag, Frigidaire. Front-load and top-load. The $89 diagnostic applies toward the repair. Twelve-month warranty on parts and labor.